![]() If you use ARM-JTAG-EW, you will need USB A-B cable. General practice for working with static sensitive devices should be applied when working with this board.Ĭables: The cable you will need depends on the programmer/debugger you use. The board must not be subject to high electrostatic potentials. The LPC-H1114 board is shipped in protective anti-static packaging. MCU: LPC1114FBD48/301/302 Cortex-M0, up to 50 Mhz, 32 kB Flash, 8kB SRAM, UART RS-485, two SSP, I2C/Fast+, ADCįR-4, 1.5 mm, soldermask, component print On the board are available Debug Interface and extension headers for all microcon-troller ports. ![]() This microcontroller sup-ports various interfaces such as one Fast-mode Plus I2C-bus interface, one RS-485/EIA-485 UART, two SSP interfaces, four general purpose timers, a 10-bit ADC. LPC-P1114 featuring a high level of integration and low power consumption. ![]() LPC-P1114 is development board with LPC1114FBD48 ARM Cortex-M0 based microcontroller for embedded applications from NXP. Revision B, June 2012Copyright(c) 2011, OLIMEX Ltd, All rights reserved All boards produced by Olimex are ROHS compliant
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |